Hi Guys, went out and replaced the convergence control board (Hitachi calls it conv. power board but it doesn`t have the flatpack IC`s on it) on this Hitachi proj. unit and still can`t converge the blue, I couldn`t get the controls to adjust far enough so I ordered the module but the replacement is only a little better, I now would have to ASSume that the flatpack(s) are bad or I`m missing a voltage somewhere, don`t have the print so any tips or ideas would be greatly appreciated (customer is not happy of course) tia, Larry E Larry Eastman American TV & Electronics Crystal River, Fl. 34428 ***************************************************************************** CHECK OUT THE NEW CHATROOM! Just login and click on chat! http://www.tech-assist.org/secure/tip/main.htm The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.htm Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/