I replaced C612 and C733 and that seems to have fixed the problem. Both caps were very low and measured bad esr. Thank you for all your help.........:-) Shaun Advanced Electronics Fort Morgan, CO 80701 (970)867-3124 ssroark@xxxxxxxx ----- Original Message ----- From: "Phil Bader" <philbad@xxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Thursday, May 23, 2002 5:49 AM Subject: [TechAssist] Re: Hitachi 31KX6b Chassis G9LXU1M > > The first thing I would consider in light of the fact it has the problem > "cold" would be an electrolytic cap bad. In the morning when cold, take > your heat gun and heat one half of the board being careful to not heat > the other side(use a cardboard devider,etc)Now power on for the first > time. If it stays on, turn off and use a can of coolant to cool a > section of that area.Try to reproduce the symptom. Get it? Maybe a cap > in the Xray protect ckt, or power supply.-Phil Bader > > Shaun wrote: > > > > This set will go into shut down when first turned on for the day but after it warms up it will come on and work fine all day. I have looked at the power supply and when it is in shut down the wave form off of pin 7 of IC 901 is off. I am using a sams 2985 and Q903 E 144 vdc B 144 vdc and C 0 vdc. The schmedic says on Q903 E 43 vdc B 42.9 and C 0 vdc. I have a similar strange dc volts on Q904, only the E is correct at 130 vdc. > > > > Shaun > > Advanced Electronics > > Fort Morgan, Co 80701 > > 970-867-3124 > > > > ------------------------------------------ > > To REMOVE your email address, click here: > > http://www.tech-assist.org/unsubb.html > > To CHANGE your email address, click here: > > http://www.tech-assist.org/change.html > > ------------------------------------------ > > ***NEW*** Tips Added Instantly!!!*** > > Submit Repair Tips here: > > http://www.tech-assist.org/secure/tip/ > > -- > Philip Bader, Jan Phyl TV Inc. > 3420 Recker Hwy,Winter Haven, Fl. 33880 > voice/fax: 863-299-8821 > Established 1976 > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.tech-assist.org/change.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.tech-assist.org/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/