[TechAssist] Re: High voltage arcing, what's the cause?
- From: "Ron Miller d.b.a. Country TV" <rlmbkm@xxxxxxxxxx>
- To: <techassist@xxxxxxxxxxxxx>
- Date: Sun, 28 Dec 2003 10:03:50 -0600
Simple, discharge remove anode from CRT clean area (carbon trails) replace
anode cup with new or good used seal with RTV if used in high humidity
area.HTH
Country TV
Ron Miller
Inez, TX. 77968
----- Original Message -----
From: "Stefaan Van Slycken" <vanslycken@xxxxxxxxxx>
To: <techassist@xxxxxxxxxxxxx>
Sent: Sunday, December 28, 2003 9:32 AM
Subject: [TechAssist] High voltage arcing, what's the cause?
> Customer gave me a coin-op arcade game (mortal combat II) with the
complaint that it crackles & smells. When switched on there's very severe
arcing around the HV cable - purple arcs from HV cable to demagnetisation
and gnd cables around the CRT. I must say that this game hadn't played in a
while and may or may not have been stored in a moist environment. What
causes these severe arcs? Bad CRT, bad LOT? I've never seen anything like
this outside a CRT before...
> kind regards,
> Stefaan Van Slycken
> Van Slycken Elektro
> Waasmunster
> BELGIUM
>
>
****************************************************************************
*
> Lost Password:
> http://www.tech-assist.org and select "Login Problems?".
> Email Archives:
> //www.freelists.org/archives/techassist/
>
>
*****************************************************************************
Lost Password:
http://www.tech-assist.org and select "Login Problems?".
Email Archives:
//www.freelists.org/archives/techassist/
Other related posts:
