For the last couple of years, that part has been NLA. You will have to figure some way to hold that part together. I was thinking nut and bolt but the threads will wear the plastic gears so a rivet would be better. Jerry Silverman Greentron Inc 4 Newland Ave Greenville SC 29609 864 232 3889 Fax 271 2080 mailto:greentron@xxxxxxx ----- Original Message ----- From: "Tri-County Tv" <tricountytv@xxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Saturday, November 09, 2002 3:34 PM Subject: [TechAssist] Go video GV-6010-need Part > Hi All, > I'm working on a Go-Video dual deck model GV-6010 , it has a small dual gear set that sits against the main clutch assembly, this little dual gear set has a plastic arm on the top and bottom and the arms are bowed so the gears do not sit properly, does any body know the part # , or is this part used in another brand, and who would sell this part. > > TIA--Thomas Berger > Tri-County Tv > Robbinsville,NC 28771 > tricountytv@xxxxxxxxxxxxx > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ > ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/