Easy to figure out Phil, just use ohm meter to locate the other primary pin(s). There should be no ohms reading to any secondary pin, then connect ringer leads across the primary. Flyback is out of circuit, right? Jim Myers jr.myers@xxxxxxxxxxx ----- Original Message ----- From: "Phil Bader" <philbad@xxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Friday, October 05, 2001 8:36 AM Subject: [TechAssist] [Fwd: RCA F25216WT, CTC185AB dead,bad HOT,regulator,open R103U.] > > > > -------- Original Message -------- > Subject: RCA F25216WT, CTC185AB dead,bad HOT,regulator,open R103U. > Date: Fri, 05 Oct 2001 09:19:13 -0400 > From: Phil Bader <philbad@xxxxxxxxxx> > Organization: Jan Phyl TV Inc. Winter Haven, Fl. Estab. 1976 > To: "CONSUMERELREPAIR-L@xxxxxxxxxxxxxxxxxxxx" > <CONSUMERELREPAIR-L@xxxxxxxxxxxxxxxxxxxx> > > Question: Before I install the reg kit 231523,HOT,resistor,I rang the > fly and get "BAD"but want to verify the correct fly pins to ring. One > lead on the HOT collector fly pin ( I assume),and where goes the other > ringer lead? (no schemo).Plse use component reference for > location.Thx,Phil > Help make your TechAssist online repair tips > database better! Submit your fixes here: > http://www.circuitwork.com/techassist/tip/#tips > To unsubscribe write to: > techassist-request@xxxxxxxxxxxxx > with unsubscribe in the subject line. Help make your TechAssist online repair tips database better! Submit your fixes here: http://www.circuitwork.com/techassist/tip/#tips To unsubscribe write to: techassist-request@xxxxxxxxxxxxx with unsubscribe in the subject line.