[TechAssist] Fw: mits
- From: "Kerry & Cherie" <alterego@xxxxxxxxxxx>
- To: <techassist@xxxxxxxxxxxxx>
- Date: Sun, 3 Feb 2002 16:26:06 -0800
Charlie,Thanks for the info,I'll replace them
anyway and check the other items mentioned.
Really appreciate the help from all! Kerry
-----Original Message-----
From: Charles Belich <seashell@xxxxxxxxxx>
To: Kerry & Cherie <alterego@xxxxxxxxxxx>
Date: Saturday, February 02, 2002 7:28 AM
Subject: Re: mits
>Hello Kerry , Mitsubishi says they breakdown in operation and check ok out
>of ckt. After you change them you must balance the CRTs. I have a manual
for
>a TS-4545 (VZ3) that might be close enought for you to work from. I can
scan
>a section or two for you if needed. On my print it shows Q6R5 =AKB-OUT
>might cause a problem too.It feeds IC-200 (on this print) CXA2025S pin 25
>(IK in) should be .4v (point 4 volts) According to this
>print................Charlie
>.
>Charles Belich
>Slidewire Electronics
>108 S. 1st. Ave KL
>Hibbing , MN 55746
>Mailto:seashell@xxxxxxxxxx
>Ph: 218-263-7090
>----- Original Message -----
>From: "Kerry & Cherie" <alterego@xxxxxxxxxxx>
>To: "Charles Belich" <seashell@xxxxxxxxxx>
>Sent: Friday, February 01, 2002 4:44 PM
>Subject: Re: mits
>
>
>Charles,I did check those parts,and they do
>check Ok so I have not changed them at
>this time..Maybe I should change them anyway?
>Kerry
>
>
>
>
>
------------------------------------------
Make your TechAssist database better!
Submit Repair Tips here: http://www.tech-assist.org/secure/tip/
------------------------------------------
To UNSUBSCRIBE your email address, click here:
mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe
Or send a BLANK email with unsubscribe in the
SUBJECT field to the address above.
Other related posts:
