Oh Thank You, Thank You, Thank You. The set came in witha STK 4151-11 Perhaps the customer took it to someone else and they put in a 4151 when they could not get a 4191. Thanks again ........ Tony PS. Try to keep the file size under 1MB. If the entire schematic is too large just scan the output stage. Jim Myers wrote: >Tony, >I have a manual for this model and the output amp ic is STK-4191, your >original post said you had installed a STK-4151-11. Could be there was a >change in parts or you may have mis-read the number on the ic. I'll scan the >schematic page and email it as an attached file tomorrow to >tonyrock@xxxxxxxxxxx >Jim Myers >jr.myers@xxxxxxxxxxx >----- Original Message ----- >From: "Chaz" <chaz@xxxxxxxxxxx> >To: <techassist@xxxxxxxxxxxxx> >Sent: Tuesday, October 30, 2001 6:53 PM >Subject: [TechAssist] Re: Fisher CA-77 > > >>Hmm, I'll have to think on this one then. The reason I made the >> >suggestion > >>was because of a similar problem with a Sony boombox I had. The left >>channel made a hum in the left channel (or would "pop" when powered >>down). Both channels showed a good audio signal signal , also. However, >>on a spectrum analyzer, it showed up different as I had suspected. I had >>already decided to replace one of the main filter caps before hand. I >> >ended > >>up replacing both to keep it a "balanced" repair. At least it worked for >> >me > >>that time. >> >>Anyway, as to the manual delima, for the heck of it sometime, you might >>take a look at our updated http://www.tech-assist.org/TECHLINKS.htm file. >>I've included some more links to Schematic pages I found and/or were sent >>to me from some of the other tech-assist users. I've manages to find a >> >few > >>out-of-print and hard-to-find ones through a few of them. >> >>Good luck >>Chaz >>chaz@xxxxxxxxxxxxxxx, chaz@xxxxxxxxxxx >> >>>The power supply is OK because the Right channel is clean. The audio >>>into the final is clean on both channels. Tannebaum is no good, I wrote >>>to them asking about cost of shipping the manual to Trinidad and I got >>>no reply after 2 weeks. No way am I going to send them any money. >>> >>>Thanks for the tip anyway I will keep the list informed if I come up >>>with anything. >>> >>>Tony >>> >>> >>>James M. Knoble wrote: >>> >>>>I don't have any specifics on this one but, I would, personaly, look at >>>> >the > >>>>power supply. The "hum" sounds a like grounding problem to me like a >>>> >bad > >>>>capacitor and this "ground noise" is making it through to the final >>>> >stages of > >>>>the amp - since you've already replaced the final. My next step would >>>> >be to > >>>>look in the preamp stages. >>>> >>>>Also, a service manual is available for $17.00 - if you are looking for >>>> >one - > >>>>from A.G. Tannebaum's site at http://www.agtannenbaum.com/ >>> >>>>The page that lists available schems for Fisher is at >>>>http://www.agtannenbaum.com/f_cat.html >>>> >>>>I'll keep looking, though. Good luck. >>>>Chaz >>>>------- >>>> >>>> >>>>>Date sent: Mon, 29 Oct 2001 05:41:08 -0400 >>>>>From: Anthony Rock <tonyrock@xxxxxxxxxxx> >>>>>To: techassist@xxxxxxxxxxxxx >>>>>Subject: [TechAssist] Need Help With Fisher CA-77 audio >>>>> >>>>amp >>>> >>>>>Send reply to: techassist@xxxxxxxxxxxxx >>>>> >>>>> >>>>> >>>>>Hello all, >>>>> >>>>>I have a Fisher CA-77 stereo amplifier that is dead on the left >>>>> >channel. > >>>>>When the customer brought it in there was just a hum on the left >>>>>channel. After doing all the usual voltage checks and finding all Ok I >>>>>replaced the audio output IC which is a STK 4151-11. It still does not >>>>>work. The left channel sounded like it was on the brink of going into >>>>>oscilation and it died again. I have no service information at all on >>>>>this amp. I have been tearing my hair out for over a week now. Can >>>>>someone please help. >>>>> >>>>>Thanks >>>>>Tony >>>>>tonyrock@xxxxxxxxxxx >>>>> >>>>> >>>>>Help make your TechAssist online repair tips >>>>>database better! Submit your fixes here: >>>>>http://www.circuitwork.com/techassist/tip/#tips >>>>>To unsubscribe write to: >>>>>techassist-request@xxxxxxxxxxxxx >>>>>with unsubscribe in the subject line. >>>>> >>>>> >>>> >>>>Help make your TechAssist online repair tips >>>>database better! Submit your fixes here: >>>>http://www.circuitwork.com/techassist/tip/#tips >>>>To unsubscribe write to: >>>>techassist-request@xxxxxxxxxxxxx >>>>with unsubscribe in the subject line. >>>> >>>> >>>>From - Tue Oct 30 03:53:56 2001 >>> >>>>X-UIDL: +>S!!gbB!!+J5!!D&/!! >>>>X-Mozilla-Status: 0009 >>>>X-Mozilla-Status2: 00000000 >>>>>From techassist-bounce@xxxxxxxxxxxxx Mon Oct 29 10:01:15 2001 >>>>Return-Path: <techassist-bounce@xxxxxxxxxxxxx> >>>>Delivered-To: tonyrock@xxxxxxxxxxx >>>>Received: (qmail 193302 invoked from network); 29 Oct 2001 >>>> >10:01:15 -0000 > >>>>Received: from unknown (HELO avenir.dhs.org) (168.215.193.75) >>>> by ns33.tstt.net.tt with SMTP; 29 Oct 2001 10:01:15 -0000 >>>>Received: from avenir.(none) (localhost [1 >>>> >>> >>> >>>Help make your TechAssist online repair tips >>>database better! Submit your fixes here: >>>http://www.circuitwork.com/techassist/tip/#tips >>>To unsubscribe write to: >>>techassist-request@xxxxxxxxxxxxx >>>with unsubscribe in the subject line. >>> >>> >> >>Help make your TechAssist online repair tips >>database better! Submit your fixes here: >>http://www.circuitwork.com/techassist/tip/#tips >>To unsubscribe write to: >>techassist-request@xxxxxxxxxxxxx >>with unsubscribe in the subject line. >> > >Help make your TechAssist online repair tips >database better! Submit your fixes here: >http://www.circuitwork.com/techassist/tip/#tips >To unsubscribe write to: >techassist-request@xxxxxxxxxxxxx >with unsubscribe in the subject line. > > Help make your TechAssist online repair tips database better! Submit your fixes here: http://www.circuitwork.com/techassist/tip/#tips To unsubscribe write to: techassist-request@xxxxxxxxxxxxx with unsubscribe in the subject line.