Hi Jim, What are the status LED's indicating? I believe you still have a lamp power supply problem. You mentioned there was a crack in the PCB. It's possible the unit needs to be reset, here's the user manual, check pages 49 & 50 for reset options. http://www.ccc.commnet.edu/media/classroomhelp/equipmanuals/Epson-PowerL ite5000.pdf - you may need to cut and paste this address into your browser if its too big. Hope this helps. David Lessard Mr_fixit@xxxxxxxxxxxx Alexandria, Ontario, Canada. -----Original Message----- From: techassist-bounce@xxxxxxxxxxxxx [mailto:techassist-bounce@xxxxxxxxxxxxx] On Behalf Of Jim Myers Sent: Tuesday, May 24, 2005 12:51 PM To: Techassist Subject: [TechAssist] Epson ELP-5000 LCD Projector, new lamp, fans run, pwr led flashes red. Need to know if lamp timer needs to be reset and how to do it. The unit had been dropped and a board was cracked, fixed that then found the pico fuse on the lamp housing was open. Got a new lamp but it does not light up. ******************************** Since 1972 * Jim Myers * Telrad Electronics * Fort Wayne Indiana * ******************************** ------------------------------------------------------------------------ ----- This Email List is Public. Remove: http://www.tech-assist.org/remove.htm Lost Password: http://www.tech-assist.org and select "Login Problems?". Appliance Repair List: http://www.tech-assist.org/secure/tip/chatjoin.htm#app Email Archives: //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- This Email List is Public. Remove: http://www.tech-assist.org/remove.htm Lost Password: http://www.tech-assist.org and select "Login Problems?". Appliance Repair List: http://www.tech-assist.org/secure/tip/chatjoin.htm#app Email Archives: //www.freelists.org/archives/techassist/