Grady, I have a Cap Wizard that has been zapped several times. All I ever had to do is replace two 1 ohm resistors and it was good to go until next time. Open it up and look for the resistors at the bottom middle of the board. Hope this helps. Good luck, Daryl Daryl's TV 3310 Dyer St. El Paso, TX 79930 915-565-9184 915-564-1024 Fax http://dynacomp.freeyellow.com -----Original Message----- From: GOMDWIL@xxxxxxx <GOMDWIL@xxxxxxx> To: techassist@xxxxxxxxxxxxx <techassist@xxxxxxxxxxxxx> Date: Thursday, October 24, 2002 10:02 PM Subject: [TechAssist] ESR Meter Zapped >Hello All, >I,ve had this Capacitor Wizard ESR meter for years but I finally got across a >hot cap. Anyone have a fix or know where I can send it for repair ? Any help >will be appreciated. It's like my right arm! Thanks, Grady > >Grady O. Wilson >Wilson's TV Service >Texarkana, Texas >gomdwil@xxxxxxx > > >------------------------------------------ >To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html >To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html >------------------------------------------ >***NEW*** Tips Added Instantly!!!*** >Submit Repair Tips here: >http://www.tech-assist.org/secure/tip/ > ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/