Al, From Tech Repair CD: DAYTEK,DT1731,CM,Hv Inop (Note: This Monitor Has To Have A Valid Signal To Make Hv):,,,Past Failures: Q501* Q502* Q503* R503* R505* R506. Also Check Ic941 12,V Reg*And Ic301 Tda9103 And Vert Ic Tda8172,,,,,,,, Jeff Dougherty Intrepid Video TV/VCR 263 S Front St Steelton PA 17113 fax...717-564-4952 www.intrepid-video.com www.tech-repair.net ----- Original Message ----- From: "Al Gutz" <alg@xxxxxxxxxxx> To: "tech assist" <techassist@xxxxxxxxxxxxx> Sent: Thursday, February 12, 2004 11:16 PM Subject: [TechAssist] Daytek monitor DT1731D Dead Fix Set was dead fornd shorted vert IC and burnt 4.7 ohm in the 26V supply to vert IC Second problem: Pic was very pale. Fil volts was down to 3V, found open 470u cap in the fil supply, restored to 6V. Al G Al's TV-Electronics Pembroke ONt. Canada ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/