won't these fire up without the GemStar module connected ??? Peggs At 12:16 PM 9/10/03, Kevin wrote: >I am still working on this dead CTC203AA5. All voltages check good, >except there is no RUN voltage of 2.8 volts when the pwr button is >pressed. I am thinking that the gemstar with built in microprocessor is >at fault. I would like to change the eeprom first before I spend the >$100 Canadian to replace the Gemstar, but none of my suppliers have this >eeprom in stock. Can I sub in a known good eeprom from some of the >older RCA chassis' like CTC176-187 for test purposes? Thanks. > >Kevin Wilks >Kevin's TV & Video Repair >Penticton BC Canada >kevintv@xxxxxxx > > > >***************************************************************************** >Classifieds! Buy or Sell! >http://sell.tech-assist.org >The Tech Address Book: >http://www.tech-assist.org/secure/tip/contact.htm >Add a Repair Tip Here, or Change/Remove your Email Address: >http://www.tech-assist.org/secure/tip/main.htm >Lost Password: >http://www.tech-assist.org and select "Lost your Login Info?". >Email Archives: >//www.freelists.org/archives/techassist/ ***************************************************************************** Classifieds! Buy or Sell! http://sell.tech-assist.org The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.htm Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/