What does pin 22 (horizontal out) of the T-chip measure? It should be 3 volts. I had one where there was solder splash on R14322 which caused a partial short to ground and pin 22 only measured 0.2 volts. Kevin Wilks Kevin's TV & Video Repair Penticton BC Canada kevintv@xxxxxxx -----Original Message----- From: techassist-bounce@xxxxxxxxxxxxx [mailto:techassist-bounce@xxxxxxxxxxxxx] On Behalf Of Keith Trumbla Sent: Monday, November 24, 2003 2:02 PM To: techassist@xxxxxxxxxxxxx Subject: [TechAssist] CTC203 Horz Drive Problems CTC203AD9 chassis. Did the coil on base etc. I mean, I really checked it well. Removed coil, stripped back some of the enamel to make a larger land for the solder to grab. Removed a re-installed driver xformer. Set will come on with no HV. Drive is not getting to Q14301 driver xistor. Resoldered surface mount Q14302 and surrounding parts. Seems to be in this area though. I put my meter on Q14302 and set came on. HELP ! Keith Trumbla BEM Electronics Inc. Suite 212-530 Century St. WPG. MB. R3H 0Y4 Canada Ph.204.775.2875 Fax.204.774.9192 www.bemelectronics.com ************************************************************************ ***** Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/ ***************************************************************************** Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/