Good evening, I have this 31" rca model F31671SE chassis ctc177cn , came in dead, replaced U4101 (STK-730-010) with a new one but unsure of where it came from, does not appear to be counterfeit, but after installing this ic the set comes on fine, then in about 5 min the picture gets wavy lines in it and eventually the picture goes in and out. When the TV is off raw 15volt source goes from 15 volts to 20 volts and the b+ goes from 140 to 212 and then you hear the buzz, turn the set on and the voltages go back to normal until you turn it off again. Has anyone seen this problem before or anything close to it? Tom Berger Tri-County TV Robbinsville North Carolina 28771 (tricountytv@xxxxxxxxxxxxx) ***************************************************************************** CHECK OUT THE NEW CHATROOM! Just login and click on chat! http://www.tech-assist.org/secure/tip/main.htm The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.htm Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/