Check C4511 It is a box cap toward the front of the board. I've had bad solder on this and internal breaks on it. Try tapping on it. Al Marquardt ampm@xxxxxxx Al Marquardt Electronic Repair 206 W Main Girardville Pa. 17935 ----- Original Message ----- From: "Peter oliver" <oliver_peter1@xxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Tuesday, December 23, 2003 12:15 AM Subject: [TechAssist] CTC169 vertical > > > Have several CTC169 sets with intermittant vertical problems, > (intermittant fluttering/colapse) Have checked the capactiors and > connections following schematic no effect get worse when warm- tap sensitive > in generalized way. Can desensitize (at least as a temporay test measure) by > placing shims under board to deflect board upward. since hese sets use a > moldulated flyback drive to run the vertilcal. I have seen several tips on > vertical problems to replace the flyback. Any one have any historys on how > often it is necessary to replace the flyback in ctc 169's to cure a vertical > problem... > > Peter Oliver > Tucson Radio TV > > _________________________________________________________________ > Check your PC for viruses with the FREE McAfee online computer scan. > http://clinic.mcafee.com/clinic/ibuy/campaign.asp?cid=3963 > > **************************************************************************** * > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > > ***************************************************************************** Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/