Only specs available around say: 900/600v 5A 50W HFE: 8-30 (they do not mention the damper diode and the base-emitter resistor you can see in the schematics' drawing). I DO NOT TRUST THOSE SPECS, too low collector voltage for a HOT, if I were you I would sub with a fairly high gain unit, like 2sd2578, 99.99999% chance of success...but if you have anything between d1878 and d1881 handy give it a try, if it runs cool you're done HTH Jorge At 02:49 p.m. 25/09/03 -0400, you wrote: >Where do I get parts for this thing? I need a D2102 which the manual says is >a 3DD2102, which doesn't cross to anything I can find. This is the HOT and >ref# is V432. Thanks. >Al Marquardt >ampm@xxxxxxx >Al Marquardt Electronic Repair >206 W Main >Girardville Pa. 17935 > > >***************************************************************************** >Classifieds! Buy or Sell! >http://sell.tech-assist.org >The Tech Address Book: >http://www.tech-assist.org/secure/tip/contact.htm >Add a Repair Tip Here, or Change/Remove your Email Address: >http://www.tech-assist.org/secure/tip/main.htm >Lost Password: >http://www.tech-assist.org and select "Lost your Login Info?". >Email Archives: >//www.freelists.org/archives/techassist/ Jorge Camboni, GY Electronics, Richardson, TX ***************************************************************************** Classifieds! Buy or Sell! http://sell.tech-assist.org The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.htm Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/