You probably will need to experiment with different value resistors to get gray scale close but, to start with take three 18 k ohm 1/2 watt resistors connect one each to red, green and blue cathodes and connect the three loose ends together. this will defeat ik blanking most of the time but if you have a weak crt the gun that is the weakest will require a higher value resistor maybe 27 k or more if you have 25 - 50 k ohm potentiometer or rheostat try using it in place of resistor on the weakest gun to adjust for best gray scale then replace with resistor Robert tvservice@xxxxxxxxxxxxx H & H Electronics Inc ----- Original Message ----- From: <BOSS1996@xxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Monday, June 20, 2005 3:11 PM Subject: [TechAssist] 1K modification > Sorry if this has been asked a million times but what exactly do you have to > do for this mod? Reading the many posts about it indicate putting a resistor > on the CRT board but there is no mention on where. Or mention of some spanish > doc. which would not be too helpful. > TIA > > > Robert Cardoza > Picture Perfect Elec. > 9940 NW 6th Ct > Pembroke Pines, Fla, 33024 > 954-435-5868 > > -------------------------------------------------------------------------- --- > This Email List is Public. Remove: http://www.tech-assist.org/remove.htm > Set Vacation mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation > Lost Password: http://www.tech-assist.org and select "Login Problems?". > Email Archives: //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- This Email List is Public. Remove: http://www.tech-assist.org/remove.htm Set Vacation mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/