[tcb] Re: Time to look for parts
- From: Will <evilscientistboo@xxxxxxxxxxxxx>
- To: <tcb@xxxxxxxxxxxxx>
- Date: Thu, 6 Sep 2007 17:53:14 -0500
annie?
-----Original Message-----
From: Denis Dodson <coocoo@xxxxxxx>
Sent: Thursday, September 06, 2007 4:46 PM
To: tcb@xxxxxxxxxxxxx
Subject: [tcb] Re: Time to look for parts
Tomorrow.
----- Original Message -----
From: Will
To: tcb@xxxxxxxxxxxxx
Sent: Thursday, September 06, 2007 4:30 PM
Subject: [tcb] Re: Time to look for parts
Sure it could. Oil rings break with age. So do compression rings. You could
also have a bad intake or exhaust valve guide.
Your first step is to pull the plugs. One of them should be oil fouled.
From: Denis Dodson <coocoo@xxxxxxx>
Sent: Thursday, September 06, 2007 3:44 PM
To: tcb@xxxxxxxxxxxxx
Subject: [tcb] Re: Time to look for parts
I have an oil temp guage and it never showed anything above 220. And I heard no
pinging. Dan and I were talking and he said I smoked a little at engine
braking for years. Couldn't a ring just give it up over time?
----- Original Message -----
From: Will Wood
To: tcb@xxxxxxxxxxxxx
Sent: Thursday, September 06, 2007 3:21 PM
Subject: [tcb] Re: Time to look for parts
Ahh, well that clarifies things. Have you pulled the plugs? If you have a
burnt piston or rings that would be causing this much smoke the plug will be
wet on that cylinder. If the timing was too far advanced resulting in pinging
or it overheated you'll have a hole in the piston or a chunk missing. If you
had a full flow on it, it should have caught *most* of the crap but once it
plugged up it would just let the oil through; garbage and all. I don't know
the config you have on your filter so I can't say if it's full flow or not.
You can always look on the bright side of things with it burning oil it does
keep the mosquito population down.
-----Original Message-----
From: Denis Dodson
Sent: Sep 6, 2007 4:10 PM
To: tcb@xxxxxxxxxxxxx
Subject: [tcb] Re: Time to look for parts
I have a remote filter, I don't know if that makes it a true full flow,
but this engine does have an absolute load of miles and age on it. When I am
accelerating all is well. When I back off the pedal I get billows of smoke. I
have been told that is indicative of a "burnt piston". It could be crap in the
oil, it could be timing too advanced and it may be a cracked ring due to age.
I still need to do a compression test and stuff before I tear into it too much.
I love my 1914 without the reduction boxes. I like to go far distances. I like
to average 68 MPH.
If I have to split the case and make a new engine I will NOT make T@P . Too
much money and too much time. Like I said, of course the "correct" thing to do
is to split the case and do a complete re-build. But if I take off the jugs and
check the heads and clean as well as I can and put in new cylinders, pistons,
[The entire original message is not included]
Other related posts:
