I changed the oil in the tranny and reduction boxes a couple of weeks ago. The transmission oil looked good but I could see a little brass in the RGB's if you looked at oil in the sunlight. The engine was rebuilt by Kermit before I installed . Sent from my iPhone > On Dec 14, 2014, at 4:00 PM, Bbauer2000 <bbauer2000@xxxxxxxxx> wrote: > > Thrust bearing in motor. How long ago was the motor rebuilt? What was the > end play? Was the case cut? > >> On Dec 14, 2014, at 3:53 PM, "Ronnie Hughes" <dmarc-noreply@xxxxxxxxxxxxx> >> (Redacted sender "fracdogii@xxxxxxxxx" for DMARC) wrote: >> >> I didn't try kicking it into neutral. >> >> Just if you are going along and push the clutch in the noise stops. >> >> From: Denis <coocoo@xxxxxxx> >> To: tcb@xxxxxxxxxxxxx >> Sent: Sunday, December 14, 2014 3:50 PM >> Subject: [tcb] Re: Technical Question Alert! >> >> It rumbles when you are rolling in neutral? >> >> From: mailto:dmarc-noreply@xxxxxxxxxxxxx >> Sent: Sunday, December 14, 2014 3:16 PM >> To: Tcb >> Subject: [tcb] Technical Question Alert! >> >> Okay, I drove my bus a couple of hundred miles this weekend and when I'm >> cruising down the highway I can hear a low roar or rumble. If I coast it >> continues, but if I push the clutch in it stops. >> >> I replaced the clutch, throw out bearing and pressure plate when I was >> rebuilding the bus so they only have a few 1,000 miles. >> >> I replaced the rear transmission mounts, but not the fronts. >> >> What do you think? >> >> Ronnie >> >> >> >> >> >> This email has been checked for viruses by Avast antivirus software. >> www.avast.com >> >> >>