HAHA yea...i need a tall cap...well got it to fit kinda..started it then the rotor ate up my cap..the coil terminal no longer has spring action ...it' sstuck up in the cap! oops..:( Fred McDonald <texasbluebus@xxxxxxxxxxx> wrote:This is certainly not my expertise and you are probably more knowable than I, but there are two different distributor caps for VWs a short cap and a tall cap. I once bought a tall cap by mistake for my 1600 and it ran like crap. perhaps you need the tall cap for the new electronic ignition. ----- Original Message ----- From: "Lee Le" To: Sent: Sunday, November 14, 2004 7:43 PM Subject: [tcb] Empi accufire conversion kit >I just tried to install the following kit//EMPI accufire conversion kit//. >I take the points out. Put the module in and bolt it. Put the accufire >rotor wheel in and install the stock rotor backon top of it. For some >reason the rotor wheel makes the rotor sit up a little too high..I cant get >the distributor cap on without trying to force it down. > I checked the wire guide that goes thru the distrubutor...installed > correctly. There is also no unnecessary gaps. Didn't use the spacer > proveded cause it's a mech advance dist. Possibilities? AM I supposed to > force the dist cap down? I took the accurfire rotor wheel out and put just > the old rotor back on..goes down perfectly. Then put the accu fire > wheel..back on..sitting flush with the dist shaft...and rotor back > on..still..wont let me put the cap on? Please help! ?? Condensor was taken > out too. > > 71 westy type 2 1600cc bosch dist. > > > --------------------------------- > Do you Yahoo!? > Check out the new Yahoo! Front Page. www.yahoo.com > > > --------------------------------- Do you Yahoo!? Check out the new Yahoo! Front Page. www.yahoo.com