Or use an empi whack tool with a breaker bar. Sammie is right about the front spindle nuts too. I've had to use heat in extreme cases to get castleated buts off rear axles even breaking them off sometimes. I now put antiseize on the threads before reassembly -- Sent from my Palm Pre On Mar 23, 2010 10:01 PM, sammie smith <bugcollections@xxxxxxxxxxxxx> wrote: Splitties are both right hand threads on both sides on the back. Assume bays are also. Not so on the front. Front axles on a splitty are left hand threads on the drivers side. So I guess if Chuck is bringing his that is one less thing I've got to remember for the show. Let me know. But, anyone with a bus and bugs needs at least 4 things in their tool arsenal: An air compressor, an air impact tool, a 36mm air socket, and a 46mm air socket. --- On Tue, 3/23/10, Ronnie Hughes <fracdogii@xxxxxxxxx> wrote: From: Ronnie Hughes <fracdogii@xxxxxxxxx> Subject: [tcb] Re: 46 mm hammer wrench To: tcb@xxxxxxxxxxxxx Date: Tuesday, March 23, 2010, 7:58 PM Thanks Chuck. I've been beating on my 15" cresent wrench and it hasn't even budged. By the way, is it a LH or RH thread? Lefty loosey, righty tighty or am I doing a good job of tightening it? From: chuck <sukchew@xxxxxxxxxxxxxx> To: tcb@xxxxxxxxxxxxx Sent: Tue, March 23, 2010 7:48:49 PM Subject: [tcb] Re: 46 mm hammer wrench Ronnie,I have one and will bring it to Nac. oleblue ----- Original Message ----- From: "Ronnie Hughes" <fracdogii@xxxxxxxxx> To: <tcb@xxxxxxxxxxxxx> Sent: Tuesday, March 23, 2010 7:42 PM Subject: [tcb] 46 mm hammer wrench > I need to borrow or buy a hammer wrench to help get the nut off the rear axle on my bus. If you have an extra or can loan until the classic bring to nac this weekend. > > > > -------------------------------------------------------------------------------- No virus found in this incoming message. Checked by AVG - www.avg.com Version: 8.5.437 / Virus Database: 271.1.1/2766 - Release Date: 03/23/10 19:33:00