[SS2S-Main] Re: temperature controller with arduino
- From: Vicente Alvero Zambrano <vicente_alvero_14@xxxxxxxxxxx>
- To: "sugarshot@xxxxxxxxxxxxx" <sugarshot@xxxxxxxxxxxxx>
- Date: Mon, 30 Jun 2014 19:55:56 +0200
I found the instruction manual for the PID. Throughout this week I will scan
and I'll upload it to this thread. See if someone can make a step by step guide
Date: Mon, 30 Jun 2014 10:08:41 -0400
Subject: [SS2S-Main] Re: temperature controller with arduino
From: jimfackert@xxxxxxxxx
To: sugarshot@xxxxxxxxxxxxx
mine too. an hour or two learning to program a $50 temp controller (maybe $100
with multiple ramps and usb with pc based programmer )
is much cheaper than the hours and learning curve to program and to properly
interface an arduino that will cost at least $100 with box and interface
circuitry.
jim fackert
On Jun 30, 2014 9:17 AM, "Vicente Alvero Zambrano"
<vicente_alvero_14@xxxxxxxxxxx> wrote:
Your opinion is to use the existing PID device?
> Subject: [SS2S-Main] Re: temperature controller with arduino
> From: waaslandwolf@xxxxxxxxx
> Date: Mon, 30 Jun 2014 14:21:03 +0200
> To: sugarshot@xxxxxxxxxxxxx
>
> I agree with Peter. Trying to save a mere 180$ by developing a solution that
> already exists isn't good use of resources.
>
> > Op 30-jun.-2014 om 00:52 heeft Peter Johansson <rockets4kids@xxxxxxxxx> het
> > volgende geschreven:
> >
> > On Sun, Jun 29, 2014 at 6:36 PM, Vicente Alvero Zambrano
> > <vicente_alvero_14@xxxxxxxxxxx> wrote:
> >
> >> My idea is to use an old oven heater like the picture.
> >> With respect to the PID controller, maybe it is cheaper to do it manually,
> >> without writing code.
> >
> > One option to consider -- and an advantage to going with a homebrew
> > solution -- is to simply read a configuration file containing the
> > temperature profile and PID tunings over over the serial port.
> >
> > This way you get the maximal possible control with the minimal
> > hardware cost and minimal software development time.
> >
> > -p.
> >
>
Other related posts: