I also just tried it and I get the same results as Clive. But again I do have
messages already. However I didn't have any issues sending a message even when
I didn't have any messages.
Good luck Dave at getting help.
Signed: Stephen Giggar
Hardware eventually fails, software eventually works.
No amount of bandwidth can fix poor design.
-----Original Message-----
From: smartvisionau-bounce@xxxxxxxxxxxxx
[mailto:smartvisionau-bounce@xxxxxxxxxxxxx] On Behalf Of Dave Van Der Molen
Sent: Thursday, December 06, 2018 3:49 PM
To: smartvisionau@xxxxxxxxxxxxx; Clive Pallett
Subject: [smartvisionau] Re: Texting with SmartVision II
Thanks Clive.
No, I'm unable to get anywhere with messaging. I've contacted Tech Support,
and they're going to help me over the Internet.
Dave
On 12/06/2018 4:46 p.m., Clive Pallett wrote:
Hello Dave,******************************************************
I have just followed the steps you described and I am prompted to
select recipients. By arrowing down, you can choose from favourites,
contacts or dial number, where you enter the number, press ok and type
your message.
can I ask: Do you have contacts stored on your phone? I cannot
understand why you are told you have no messages. If you just arrow
down when you open the messaging app, you will have no conversations.
You have to select the New Message button and you will be prompted as
I said above.
I hope this helps.
Best wishes,
Clive Pallett
******************************************************
To post to SmartVisionAU, send email to: SmartVisionAU@xxxxxxxxxxxxx
Replies to emails on this list will go to the list by default.
General information about the list,ways to join, leave and set options
is at: //www.freelists.org/list/SmartVisionAU
