Did you try resetting the screen reader back to the defaults?
After the phone has started up!
Press the Phone button.
Now Press Hash 111 Hash. That is press the lower Right hand button below the
number 9, then press the 1 three times and then press the lower right hand
button again. This will reset the screen reader back to its defaults.
Signed: Stephen Giggar
Hardware eventually fails, software eventually works.
No amount of bandwidth can fix poor design.
-----Original Message-----
From: smartvisionau-bounce@xxxxxxxxxxxxx
[mailto:smartvisionau-bounce@xxxxxxxxxxxxx] On Behalf Of Vivien Palcic
Sent: Sunday, March 28, 2021 10:26 PM
To: smartvisionau@xxxxxxxxxxxxx
Subject: [smartvisionau] SmartVision2 not talking even after removing battery,
putting it back in and charging the phone!
Hi Sam/list,
I've already tried this process twice - removing the battery, putting it back
in and leaving the phone to charge. Even when I turn it on and the musical
sound comes on, I only get the vibration indicating it has booted up, and no
speech either when I try arrowing, bringing up the main menu etc. Sam, I've
also tried ringing you earlier using my landline phone, but after several
rings, I concluded posting here would be quicker.
Regards
Vivien
******************************************************
To post to SmartVisionAU, send email to:
SmartVisionAU@xxxxxxxxxxxxx
Replies to emails on this list will go to the list by default.
General information about the list,ways to join, leave and set options is at:
//www.freelists.org/list/SmartVisionAU
******************************************************
To post to SmartVisionAU, send email to:
SmartVisionAU@xxxxxxxxxxxxx
Replies to emails on this list will go to the list by default.
General information about the list,ways to join, leave and set options is at:
//www.freelists.org/list/SmartVisionAU