Is your question how to hold-up your reference to 2.5V, or are you asking something else? The shunt regulator absorbs current that would otherwise go to the load. If the regulator is dropping out, then the source impedance is too high. Steve. On 1/6/2013 1:18 AM, Sudarshan H c wrote: > Hi experts, > i am designing shunt voltage reference of 2.5volts but if my load is > approximately 50mA, reference voltage will reduce to 2 volts,so to get > sustain output what logic should i use??? > Regards,Sudarshan > ------------------------------------------------------------------ > To unsubscribe from si-list: > si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field > > or to administer your membership from a web page, go to: > //www.freelists.org/webpage/si-list > > For help: > si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field > > > List forum is accessible at: > http://tech.groups.yahoo.com/group/si-list > > List archives are viewable at: > //www.freelists.org/archives/si-list > > Old (prior to June 6, 2001) list archives are viewable at: > http://www.qsl.net/wb6tpu > > > -- Steve Weir IPBLOX, LLC 150 N. Center St. #211 Reno, NV 89501 www.ipblox.com (775) 299-4236 Business (866) 675-4630 Toll-free (707) 780-1951 Fax All contents Copyright (c)2012 IPBLOX, LLC. All Rights Reserved. This e-mail may contain confidential material. If you are not the intended recipient, please destroy all records and notify the sender. ------------------------------------------------------------------ To unsubscribe from si-list: si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field or to administer your membership from a web page, go to: //www.freelists.org/webpage/si-list For help: si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field List forum is accessible at: http://tech.groups.yahoo.com/group/si-list List archives are viewable at: //www.freelists.org/archives/si-list Old (prior to June 6, 2001) list archives are viewable at: http://www.qsl.net/wb6tpu