When laying out microstrip 50 Ohm single-ended or 100 Ohm differential
traces, it is OK to use the same layer as the reference for targeting
the trace impedance (if the laminate is very thick between adjacent
signal layers in a 2-layer stack up, e.g. 55 mils)? The signal traces
are routed next to ground on the same layer. I've only seen online PCB
calculators with a plane below the signal trace(s). Are there any online
calculators to compute the impedance when the ground reference is on the
same layer?
------------------------------------------------------------------
To unsubscribe from si-list:
si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field
or to administer your membership from a web page, go to:
//www.freelists.org/webpage/si-list
For help:
si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field
List forum is accessible at:
http://tech.groups.yahoo.com/group/si-list
List archives are viewable at:
//www.freelists.org/archives/si-list
Old (prior to June 6, 2001) list archives are viewable at:
http://www.qsl.net/wb6tpu