Hi folks I have to make a simulation vs measurement correlation for LVDS channel (EYE Diagram) I`m wondering how to properly model the HF LeCroy differential probes (LeCroy D600ST) http://www.trs-rentelco.com/Specification/LEC_WL600_Spec.pdf I tried to take a look in Internet, but still have not found anything useful. I think I should have to put a 100ohm differential load and some smal cap (around 1pF or even less) at positive and negative terminal... do you have any suggestion? thanks a lot in advance Regards *Cristian Gozzi, M.Sc* *Infineon Technologies Austria AG* Chip-Package-Board Codesign ------------------------------------------------------------------ To unsubscribe from si-list: si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field or to administer your membership from a web page, go to: //www.freelists.org/webpage/si-list For help: si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field List forum is accessible at: http://tech.groups.yahoo.com/group/si-list List archives are viewable at: //www.freelists.org/archives/si-list Old (prior to June 6, 2001) list archives are viewable at: http://www.qsl.net/wb6tpu