Hello everyone, I have some basic questions on the measurement with Network analyzer. Please refer to the attached file for detials. Basically, we can see it as a two port network: input and output. What I want is to inject some current transient with very fast slope at the input(incident), and measure the current transient at the output(transmitted). By doing this, I can see how good the circuit or DUT can reject the high frequency di/dt noise, which is proportional to the EMI as all you guys know. My questions here are : 1. Is it possible ? 2. How can I inject fast transient current ? ( I have current probe -CT6 in my lab) 3. How to set it up ? hope you can help me out , thanks a lot ! Junfeng -- Junfeng Zhou K.U.Leuven, Dept. Elektrotechniek ESAT-MICAS Kasteelpark Arenberg 10, Room 91.33 B-3001 Heverlee Belgium Tel: +32 16 321169 Fax: +32 16 321975 Web: http://www.esat.kuleuven.be/micas/ -- Binary/unsupported file stripped by Ecartis -- -- Type: application/pdf -- File: didt TF.pdf ------------------------------------------------------------------ To unsubscribe from si-list: si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field or to administer your membership from a web page, go to: //www.freelists.org/webpage/si-list For help: si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field List FAQ wiki page is located at: http://si-list.org/wiki/wiki.pl?Si-List_FAQ List technical documents are available at: http://www.si-list.org List archives are viewable at: //www.freelists.org/archives/si-list or at our remote archives: http://groups.yahoo.com/group/si-list/messages Old (prior to June 6, 2001) list archives are viewable at: http://www.qsl.net/wb6tpu