Hi All, I have a design that has a 33MHz PCI bus. There are one master (CPU) and five PCI devices on the bus and these devices are connected in a daisy-chain topology. There's a serial termination of 33 Ohms at the beginning of the bus and an end termination of 3K at the end of the bus. The setup and hold times of this PCI bus in my design are within the spec.; however, the rise and fall times (slew rates) are not. The rates are too slow (less than 1) compared to the spec (1 to 4). Changing the value of the serial termination to O Ohm helps a little, but it still does not meet the spec. Can you help me fix this issue? Thanks, Kenny --------------------------------- It's here! Your new message! Get new email alerts with the free Yahoo! Toolbar. ------------------------------------------------------------------ To unsubscribe from si-list: si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field or to administer your membership from a web page, go to: //www.freelists.org/webpage/si-list For help: si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field List technical documents are available at: http://www.si-list.net List archives are viewable at: //www.freelists.org/archives/si-list or at our remote archives: http://groups.yahoo.com/group/si-list/messages Old (prior to June 6, 2001) list archives are viewable at: http://www.qsl.net/wb6tpu