Hi Arun,
It is not the frequency of the signal you need to consider, rise/fall time
of the signal matters.
What is the driver impedance you are using and what is the series
termination value?
Regards
Sreekanth
On Mon, Jun 12, 2017 at 4:32 PM, Arun Kumar K <
ArunKumar.K@xxxxxxxxxxxxxxxxxxx> wrote:
Hi SI Engineers,
As the pulse(10MHz, 10inch length) propogates along the trace, If the
potential is not uniform at all the points of the trace then we call this
trace as a Distributed system.
The same pulse (10MHz, 1inch length) propogates along the trace, If the
potential almost uniform in all the parts of the trace then we call this
one as lumped system.
I am have a signal(10MHz, 10inch length) transmitted through PCB, At the
receiver end having lot ringing and monotonic signals and I am keeping a
series termination.
then not much ringing and monotonic signals are reduced.
Series termination is used to match the source impedence to transmission
line impedence right?
Recent days mostly all the digital signls are Distributed signals then how
we are protecting these signals form ringing and noise?
Please correct me if I am wrong.
Thanks & Regards
Arunkumar K
L&T Technology Services Ltd
www.LntTechservices.com<http://www.lnttechservices.com/>
This Email may contain confidential or privileged information for the
intended recipient (s). If you are not the intended recipient, please do
not use or disseminate the information, notify the sender and delete it
from your system.
------------------------------------------------------------------
To unsubscribe from si-list:
si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field
or to administer your membership from a web page, go to:
//www.freelists.org/webpage/si-list
For help:
si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field
List forum is accessible at:
http://tech.groups.yahoo.com/group/si-list
List archives are viewable at:
//www.freelists.org/archives/si-list
Old (prior to June 6, 2001) list archives are viewable at:
http://www.qsl.net/wb6tpu
