If you do decide the discontinuity is unacceptable, you may be able to add a compensatory capacitance with a ground via or a spur that approaches the complimentary signal. Prashanth Rajappan wrote: > Hi , > For the LVDS pair (with low frequency signal) in my board has target > impedance is 100 Ohms. The trace width required (microstrip - 2Layer board > stack) is 14mils according to the calcuation. > However from the pads of the lvds transmitter max trace width that can be > taken out is 8 mill without any DRC issue. Will there be any problem if i > neck the trace to 8 mils to take out route from pads w.r.t perfomance?Can > someone suggest a possible soultion. > thanks in advance !!! > Prasanth > > ------------------------------------------------------------------ > To unsubscribe from si-list: > si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field > > or to administer your membership from a web page, go to: > //www.freelists.org/webpage/si-list > > For help: > si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field > > > List technical documents are available at: > http://www.si-list.net > > List archives are viewable at: > //www.freelists.org/archives/si-list > > Old (prior to June 6, 2001) list archives are viewable at: > http://www.qsl.net/wb6tpu > -- David Palmer Assistant to Ivan Yulaev office: 858-454-3419 x 30 cell: 760-791-0061 This analogy is like lifting yourself by your own bootstraps. ------------------------------------------------------------------ To unsubscribe from si-list: si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field or to administer your membership from a web page, go to: //www.freelists.org/webpage/si-list For help: si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field List technical documents are available at: http://www.si-list.net List archives are viewable at: //www.freelists.org/archives/si-list Old (prior to June 6, 2001) list archives are viewable at: http://www.qsl.net/wb6tpu