Hi All,
I am doing PDN analysis with simulation tool.
I am confused with relation between Target impedence and noise voltage.
Taget impedence will be calculated based on -> Target impedence=Voltage
tolerence/50% Load current
That means ->Target impedence= Allowed ripple voltage/Transient current
With the same assumption, I am doing the simulation by injecting the 50% load
current into the Power plane in few ports(sinkpoints)
Each sink points will draw different amount of current.
After doing the simulation based on the above assumption, I am getting a noise
voltage plot with different frequency( Noise voltage vs Frequency +10MHz
increment)
How I have to relate noise into the target impdence?
Thanks & Regards
Arunkumar K
L&T Technology Services Ltd
www.LntTechservices.com<http://www.lnttechservices.com/>
This Email may contain confidential or privileged information for the intended
recipient (s). If you are not the intended recipient, please do not use or
disseminate the information, notify the sender and delete it from your system.
------------------------------------------------------------------
To unsubscribe from si-list:
si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field
or to administer your membership from a web page, go to:
//www.freelists.org/webpage/si-list
For help:
si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field
List forum is accessible at:
http://tech.groups.yahoo.com/group/si-list
List archives are viewable at:
//www.freelists.org/archives/si-list
Old (prior to June 6, 2001) list archives are viewable at:
http://www.qsl.net/wb6tpu
