Hello Bakshan,
I worked on this project along with Eric. It looks like the misalignment is
an uncontrollable part of the fabrication process.
The misalignment might be one of the reasons, for the reported glass weave
skew measurements being all over the place.
Thanks,
Best Regards,
Venkata Satya Sai Dharma Teja Paladugu
Graduate Masters Student
Electrical Engineering
University of Colorado Boulder
Boulder, CO
+17204017282
On Fri, Mar 17, 2017 at 5:22 AM, Boris Bakshan <bbakshan@xxxxxxxxx> wrote:
Hi experts,
Following Eric's paper on designcon and the conclusions regarding the
inherent misalignment of the glass bundles with respect to the edge of the
board, could it be that some of the laminate manufacturers took initiative
to help mitigating the skew problem caused by the way fabrics are built for
so many years?
(
https://www.signalintegrityjournal.com/ext/resources/article-images-
2017/4103/4103_SIJ_GlassWeave.pdf
)
------------------------------------------------------------------
To unsubscribe from si-list:
si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field
or to administer your membership from a web page, go to:
//www.freelists.org/webpage/si-list
For help:
si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field
List forum is accessible at:
http://tech.groups.yahoo.com/group/si-list
List archives are viewable at:
//www.freelists.org/archives/si-list
Old (prior to June 6, 2001) list archives are viewable at:
http://www.qsl.net/wb6tpu
