[SI-LIST] FW: Re: Fwd: ripples on SDD21 plot

  • From: Ryan Lott <ryan.lott.ee@xxxxxxxxx>
  • To: Gert.Havermann@xxxxxxxxxxx, swagguy09@xxxxxxxxx, si-list@xxxxxxxxxxxxx
  • Date: Tue, 26 Apr 2016 12:13:07 -0500

I agree with Gert. TBH, there's not really enough information to describe
your situation properly. This issue could be as easy as a plot
scaling difference between you and the other lab and your fixtures are
"crap". But I'll assume that isn't the case.
On one hand, it's possible that the single ended to mixed mode conversion
formulas aren't matching to your measurement topology (example: 1->2,3->4);
but judging from your response, it seems unlikely since you wouldn't see
your SDD21 starting near 0dB at low freq. If that we're the case, you'd be
asking a question about that instead of this.

On the other hand, it could be calibration. If you're doing a mechanical
SOLT calibration, you definitely have a high chance of running into source
match issues, especially at the higher the frequency you go, and ESPECIALLY
if you're not using a torque wrench. Source Match has everything to do with
the uncertainty of large reflections. Two of your standards are large
reflections, so if you get this wrong then yes, you'll definitely have
"ripple" issues, ESPECIALLY if your DUT+Fixture Measurement has bad coaxial
to PCB connector launches too. With SOLT, the calibration depends on
quality connections because this is how it's done in the high quality labs
(such as NIST) that actually characterize the standards. This is one of the
reasons why I much rather prefer electronic calibration.

-A cheap and easy way to test the validity of the calibration is to just
use a THRU barrel.
-Another cheap way is to just leave your test lines hanging open, sweep,
and check S11,S22,S33,S44,...,Snn from 0-~14Ghz. The RL should be 0dB and
on the right hand side of the smith chart. Don't go past ~14GHz though
since the cables will be radiating after that.

At the end of the day, do the math. Look at the frequency distance between
peaks in the RL. This describes the distance between 2 strong
discontinuities. Use the formulate TD=1/(2*Fdistance) to get the Time Delay
between discontinuities. Does the TD you calculated make sense? Is it
physically possible to be having these ripples in your data? Don't be
afraid to also look in the time domain to see what's going on.
Ryan Lott
Spectra 7 Microsystems Ltd.
Ryan.lott@xxxxxxxxxxxx


------------------------------------------------------------------
To unsubscribe from si-list:
si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field

or to administer your membership from a web page, go to:
//www.freelists.org/webpage/si-list

For help:
si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field


List forum  is accessible at:
               http://tech.groups.yahoo.com/group/si-list

List archives are viewable at:     
                //www.freelists.org/archives/si-list
 
Old (prior to June 6, 2001) list archives are viewable at:
                http://www.qsl.net/wb6tpu
  

Other related posts: