Yes,as steve said,why do you need bead for SPI...bead can be used to reduce leakage current noise if you design mixed power... -bala On Aug 30, 2012 4:22 PM, "Tayyab Rahimkhan Pathan" < Tayyab_Pathan@xxxxxxxxxxx> wrote: > Hi, > I have to use a Ferrite Bead (FB) for SPI bus interface signal line > protection. Which will be preferred impedance 33E @ 100MHz or 120E @ 100MHz. > I think 33E @ 100MHz specs FB will be good for SPI bus or will it be > dependent on driver and trace impedance? > Pls help. > > Regards, > Tayyab > > **************** CAUTION - Disclaimer ***************** > This e-mail contains PRIVILEGED AND CONFIDENTIAL INFORMATION intended > solely > for the use of the addressee(s). If you are not the intended recipient, > please > notify the sender by e-mail and delete the original message. Further, you > are not > to copy, disclose, or distribute this e-mail or its contents to any other > person and > any such actions are unlawful. This e-mail may contain viruses. Infosys > has taken > every reasonable precaution to minimize this risk, but is not liable for > any damage > you may sustain as a result of any virus in this e-mail. You should carry > out your > own virus checks before opening the e-mail or attachment. Infosys reserves > the > right to monitor and review the content of all messages sent to or from > this e-mail > address. Messages sent to or from this e-mail address may be stored on the > Infosys e-mail system. > ***INFOSYS******** End of Disclaimer ********INFOSYS*** > > ------------------------------------------------------------------ > To unsubscribe from si-list: > si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field > > or to administer your membership from a web page, go to: > //www.freelists.org/webpage/si-list > > For help: > si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field > > > List forum is accessible at: > http://tech.groups.yahoo.com/group/si-list > > List archives are viewable at: > //www.freelists.org/archives/si-list > > Old (prior to June 6, 2001) list archives are viewable at: > http://www.qsl.net/wb6tpu > > > ------------------------------------------------------------------ To unsubscribe from si-list: si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field or to administer your membership from a web page, go to: //www.freelists.org/webpage/si-list For help: si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field List forum is accessible at: http://tech.groups.yahoo.com/group/si-list List archives are viewable at: //www.freelists.org/archives/si-list Old (prior to June 6, 2001) list archives are viewable at: http://www.qsl.net/wb6tpu