Hi Gurus, I am relatively new to PCBs and SI. I have a small query on the PCB trace shapes. Currently the PCB trace cross-sections are rectangular (may not be exact due to process constraints). If the cross-section happens to be circular, what affect it will have on the SI( any Pros and Cons). Regards, Paniraj G DISCLAIMER: This message (including attachment if any) is confidential and may be privileged. Before opening attachments please check them for viruses and defects. MindTree Consulting Limited (MindTree) will not be responsible for any viruses or defects or any forwarded attachments emanating either from within MindTree or outside. If you have received this message by mistake please notify the sender by return e-mail and delete this message from your system. Any unauthorized use or dissemination of this message in whole or in part is strictly prohibited.Please note that e-mails are susceptible to change and MindTree shall not be liable for any improper, untimely or incomplete transmission. E-mail may contain viruses. Before opening attachments please check them for viruses and defects. While MindTree Consulting Limited (MindTree) has put in place checks to minimize the risks, MindTree will not be responsible for any viruses or defects or any forwarded attachments emanating either from within MindTree or outside. ------------------------------------------------------------------ To unsubscribe from si-list: si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field or to administer your membership from a web page, go to: //www.freelists.org/webpage/si-list For help: si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field List technical documents are available at: http://www.si-list.net List archives are viewable at: //www.freelists.org/archives/si-list or at our remote archives: http://groups.yahoo.com/group/si-list/messages Old (prior to June 6, 2001) list archives are viewable at: http://www.qsl.net/wb6tpu