Thank you all very much. Please find the attached figure. I downloaded the IBIS model from TI and spartan websites. Also I used different drive strengths but no improvement. Regards, Ravi On Sat, Nov 23, 2013 at 5:20 PM, bala <balaseven@xxxxxxxxx> wrote: > Ravi, > Pls check driver's input impedance and use low strength model if your tline > is short.check your package model too. > Regard > bala > On 23 Nov 2013 21:34, "steve weir" <weirsi@xxxxxxxxxx> wrote: > > No. > > > > Check your models and your simulation set-up. > > > > Steve. > > On 11/23/2013 7:48 AM, ravikumar potluri wrote: > > > Hello friends, > > > If the slew rate of driver is much higher than the slew rate of > receiver > > > does this cause reflections on the transmission line? > > > > > > > > > I am simulating ADS62P49, 250 MSPS ADC chip (Driver) with Spartan > 3A-DSP > > > (Reciever). I see lot of ringing at the output even when the chips are > > > connected directly with termination in between and with no transmission > > > line. > > > > > > Could someone explain this? > > > > > > Thanks and Regards, > > > Ravi > > > > > > > > > ------------------------------------------------------------------ > > > To unsubscribe from si-list: > > > si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field > > > > > > or to administer your membership from a web page, go to: > > > //www.freelists.org/webpage/si-list > > > > > > For help: > > > si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field > > > > > > > > > List forum is accessible at: > > > http://tech.groups.yahoo.com/group/si-list > > > > > > List archives are viewable at: > > > //www.freelists.org/archives/si-list > > > > > > Old (prior to June 6, 2001) list archives are viewable at: > > > http://www.qsl.net/wb6tpu > > > > > > > > > > > > > > > -- > > Steve Weir > > IPBLOX, LLC > > 1580 Grand Point Way > > MS 34689 > > Reno, NV 89523-9998 > > www.ipblox.com > > > > (775) 299-4236 Business > > (866) 675-4630 Toll-free > > (707) 780-1951 Fax > > > > All contents Copyright (c)2013 IPBLOX, LLC. All Rights Reserved. > > This e-mail may contain confidential material. > > If you are not the intended recipient, please destroy all records > > and notify the sender. > > > > ------------------------------------------------------------------ > > To unsubscribe from si-list: > > si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field > > > > or to administer your membership from a web page, go to: > > //www.freelists.org/webpage/si-list > > > > For help: > > si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field > > > > > > List forum is accessible at: > > http://tech.groups.yahoo.com/group/si-list > > > > List archives are viewable at: > > //www.freelists.org/archives/si-list > > > > Old (prior to June 6, 2001) list archives are viewable at: > > http://www.qsl.net/wb6tpu > > > > > > > > > ------------------------------------------------------------------ > To unsubscribe from si-list: > si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field > > or to administer your membership from a web page, go to: > //www.freelists.org/webpage/si-list > > For help: > si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field > > > List forum is accessible at: > http://tech.groups.yahoo.com/group/si-list > > List archives are viewable at: > //www.freelists.org/archives/si-list > > Old (prior to June 6, 2001) list archives are viewable at: > http://www.qsl.net/wb6tpu > > > ------------------------------------------------------------------ To unsubscribe from si-list: si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field or to administer your membership from a web page, go to: //www.freelists.org/webpage/si-list For help: si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field List forum is accessible at: http://tech.groups.yahoo.com/group/si-list List archives are viewable at: //www.freelists.org/archives/si-list Old (prior to June 6, 2001) list archives are viewable at: http://www.qsl.net/wb6tpu