My first question would be how you measured Dk/Df on the board.
Scott McMorrow, CTO Signal Integrity Group
Samtec
Office 401-284-1827 | +1-800-726-8329
www.samtec.com
-----Original Message-----
From: si-list-bounce@xxxxxxxxxxxxx [mailto:si-list-bounce@xxxxxxxxxxxxx] On ;
Behalf Of Hung Dang
Sent: Wednesday, May 16, 2018 9:22 PM
To: si-list@xxxxxxxxxxxxx
Subject: [SI-LIST] Dk/Df value is increased very much after fabric progress firs
Dear Expert,
When I run SI simulation, I apply Dk/Df of PCB material from datasheet.
After fabric progress, I measured on the actual board, Dk is increased 28.7%
(3.65 --> 4.7) and 41.6%(0.012 --> 0.017) for Df when comparing with value in
datasheet.
So I have concerns below:
1/. What is the Dk/Df worst value which I should apply to simulation phase?
2/. Could you help to list some application note or paper which talk about this
issue?
Thank you so much.
--
-------------------------------------------------------------------------------
MS Hung-Dang Ngoc
Email: hungdn.hcmut@xxxxxxxxx <phandainghiamnc@xxxxxxxxx>
Phone: +84 1682 405 564
Skype/Facebook: hungdn.hcmut
------------------------------------------------------------------
To unsubscribe from si-list:
si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field
or to administer your membership from a web page, go to:
//www.freelists.org/webpage/si-list
For help:
si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field
List forum is accessible at:
http://tech.groups.yahoo.com/group/si-list
List archives are viewable at:
//www.freelists.org/archives/si-list
Old (prior to June 6, 2001) list archives are viewable at:
http://www.qsl.net/wb6tpu
This email and any appended documents are only for the intended person/entity
and may contain information of Samtec, Inc., that is PRIVILEGED, PROPRIETARY,
CONFIDENTIAL, AND/OR PROTECTED BY LAW. If you are not the intended recipient
you are hereby notified that any dissemination, disclosure, use or copying of
this email or its contents is prohibited. If you received this message in
error, please notify Samtec immediately and delete the email, attachments and
all copies. The intended recipient should not disclose the content to third
parties or reproduce the content without Samtec’s written consent.
------------------------------------------------------------------
To unsubscribe from si-list:
si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field
or to administer your membership from a web page, go to:
//www.freelists.org/webpage/si-list
For help:
si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field
List forum is accessible at:
http://tech.groups.yahoo.com/group/si-list
List archives are viewable at:
//www.freelists.org/archives/si-list
Old (prior to June 6, 2001) list archives are viewable at:
http://www.qsl.net/wb6tpu