Dear Expert,
When I run SI simulation, I apply Dk/Df of PCB material from datasheet.
After fabric progress, I measured on the actual board, Dk is increased
28.7% (3.65 --> 4.7) and 41.6%(0.012 --> 0.017) for Df when comparing with
value in datasheet.
So I have concerns below:
1/. What is the Dk/Df worst value which I should apply to simulation phase?
2/. Could you help to list some application note or paper which talk about
this issue?
Thank you so much.
--
-------------------------------------------------------------------------------
MS Hung-Dang Ngoc
Email: hungdn.hcmut@xxxxxxxxx <phandainghiamnc@xxxxxxxxx>
Phone: +84 1682 405 564
Skype/Facebook: hungdn.hcmut
------------------------------------------------------------------
To unsubscribe from si-list:
si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field
or to administer your membership from a web page, go to:
//www.freelists.org/webpage/si-list
For help:
si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field
List forum is accessible at:
http://tech.groups.yahoo.com/group/si-list
List archives are viewable at:
//www.freelists.org/archives/si-list
Old (prior to June 6, 2001) list archives are viewable at:
http://www.qsl.net/wb6tpu