Hello Is there any relationship between the Q factor and frequency tolerance of a crystal? Can I assume both to be the same quantity? -Ashish Raymond Anderson wrote: > Ashish- > > Perhaps these numbers will be of use to you. These are some typical > parameters for a few assorted AT cut crystals in the 3-10 MHz range. > > Freq Lm (H) Cm (pF) Co (pF) ESR (ohms) Q > 3.58 0.13 0.0152 3.35 58 > 50,000 > 5.0 0.098 0.0134 2.275 12.8 > 240,000 > 10.0 0.020 0.0126 2.8 6.3 > 200,000 > > > ---+---Lm-----Cm-----ESR---+---- > | | > +---------Co---------------+ > > Depending on the quality of the crystals the ESR and Q can vary quite a > bit with high quality commercial and communications quality parts having > much lower ESR and higher Q as compared to the common mass produced > consumer parts. As I mentioned these parameters are for AT cut crystals. > Other cuts may have somewhat different characteristics. > > -Ray Anderson WB6TPU > > Senior Signal Integrity Staff Engineer > Xilinx Inc. > > > Ashish PANPALIA wrote: > > >>Thank you Ray, >>The sites are really useful. But I have one query regarding crystal >>model. For simulation of crystal oscillator I need the crystal model. >>Though L and C value I can estimate based on my requirement what should >>be the range of R value for crystal in my application? >> >>regards, >>Ashish >> >> > > > ------------------------------------------------------------------ > To unsubscribe from si-list: > si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field > > or to administer your membership from a web page, go to: > //www.freelists.org/webpage/si-list > > For help: > si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field > > List FAQ wiki page is located at: > http://si-list.org/wiki/wiki.pl?Si-List_FAQ > > List technical documents are available at: > http://www.si-list.org > > List archives are viewable at: > //www.freelists.org/archives/si-list > or at our remote archives: > http://groups.yahoo.com/group/si-list/messages > Old (prior to June 6, 2001) list archives are viewable at: > http://www.qsl.net/wb6tpu > > ------------------------------------------------------------------ To unsubscribe from si-list: si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field or to administer your membership from a web page, go to: //www.freelists.org/webpage/si-list For help: si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field List FAQ wiki page is located at: http://si-list.org/wiki/wiki.pl?Si-List_FAQ List technical documents are available at: http://www.si-list.org List archives are viewable at: //www.freelists.org/archives/si-list or at our remote archives: http://groups.yahoo.com/group/si-list/messages Old (prior to June 6, 2001) list archives are viewable at: http://www.qsl.net/wb6tpu