[SI-LIST] Connector maintenance
- From: Low Jerry <wenghigh@xxxxxxxxx>
- To: si-list@xxxxxxxxxxxxx
- Date: Wed, 3 Oct 2012 10:11:36 +0800
Dear all,
I have a very general question, generally the connectors that we use such
as SMA, Rosenberger etc will experience wear and tear as we use it.
Typically its not an issue until we see that the deterioration starts to
impact the measurements significantly which is becoming a concern as we
move into higher speeds. Then we start to debug. My question is besides
doing a check (TDR etc) on the connectors every time before we take a
measurement, what is the best way to avoid this situation ? What
is standard practice in the industry used to address this issue.
Thanks in advance.
------------------------------------------------------------------
To unsubscribe from si-list:
si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field
or to administer your membership from a web page, go to:
//www.freelists.org/webpage/si-list
For help:
si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field
List forum is accessible at:
http://tech.groups.yahoo.com/group/si-list
List archives are viewable at:
//www.freelists.org/archives/si-list
Old (prior to June 6, 2001) list archives are viewable at:
http://www.qsl.net/wb6tpu
Other related posts:
