Before the short, there is a charge on the capacitor (defined by the voltage across the cap and the size of the cap.) If the cap is shorted, this charge "dumps" through the cap. How high that current "dump" is depends on the amount of charge, the time it takes for the cap to short (probably not instantaneous), and the internal resistance of the cap. That current "dump" is likely to be more than the steady state limiting current defined by the voltage and the resistor. So, yes, there will likely be a very short, high-current spike that exceeds the resistor current at the moment of the short. At 07:07 PM 11/6/2007, Jack Mosley wrote: >Hello, >To evaluate capacitor reliability in THB condition, a circuit using >power supply and limiting current resistor connected to the >capacitor is used. If a short occurs between the capacitor pin, is >the current will exceed the resistor limited current for a short >period of time ? > > _______________________________________________________________________________________________ Check out UltraCAD's PCB trace and impedance calculators at http://www.ultracad.com ------------------------------------------------------------------ To unsubscribe from si-list: si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field or to administer your membership from a web page, go to: //www.freelists.org/webpage/si-list For help: si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field List technical documents are available at: http://www.si-list.net List archives are viewable at: //www.freelists.org/archives/si-list or at our remote archives: http://groups.yahoo.com/group/si-list/messages Old (prior to June 6, 2001) list archives are viewable at: http://www.qsl.net/wb6tpu