Dear experts, In the compact-PCI spec (PICMG 2.0 R3.0) on page 25, they describe the next signals: PRST#,DEG#,FAL#,INTP and INTS, all these signals are TTL signals described on page 25. But my question is, when it shall be a TTL signal level then I need to use a 5V level signal, wright? Or can i take also a 3.3V level signal for those signals???? In my design I use a V(I/O) of 3.3V. My next question is: How to use the GA(4..0) signals on my system board, how do I need to connect this?? Best regards, Nico Nico Fleurinck Junior Design Engineer VERHAERT Satellites & Platforms Hogenakkerhoekstraat 21 B-9150 Kruibeke Tel : +32 3 250.1984 Fax : +32 3 254.1008 e-mail : nico.fleurinck@xxxxxxxxxxxx Visit us : www.verhaert.com ------------------------------------------------------------------ To unsubscribe from si-list: si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field or to administer your membership from a web page, go to: //www.freelists.org/webpage/si-list For help: si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field List archives are viewable at: //www.freelists.org/archives/si-list or at our remote archives: http://groups.yahoo.com/group/si-list/messages Old (prior to June 6, 2001) list archives are viewable at: http://www.qsl.net/wb6tpu