Hello - I am afraid I have no idea what you just said..
-----Original Message-----
From: si-list-bounce@xxxxxxxxxxxxx <si-list-bounce@xxxxxxxxxxxxx> On Behalf Of
Sen Velmurugan
Sent: Wednesday, September 9, 2020 2:53 PM
To: si-list@xxxxxxxxxxxxx
Subject: [SI-LIST] Re: ANSYS Q2D & Q3D Extracted L & C
This message originated outside of DISH and was sent by:
si-list-bounce@xxxxxxxxxxxxx
Thanks for the information shared on the tools behavior and interpretation of
the results.
I like to look into this issue as nonexistent.
Looking from mile high, The issue is, which "yardstick" is to be used to for
channel, then I would say the same "yardstick" used for source and load.
How requirements are conceived, specified and measured need to be in sync.
Thanks
Sen Velmurugan
------------------------------------------------------------------
To unsubscribe from si-list:
si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field
or to administer your membership from a web page, go to:
//www.freelists.org/webpage/si-list
For help:
si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field
List forum is accessible at:
http://tech.groups.yahoo.com/group/si-list
List archives are viewable at:
//www.freelists.org/archives/si-list
Old (prior to June 6, 2001) list archives are viewable at:
http://www.qsl.net/wb6tpu
------------------------------------------------------------------
To unsubscribe from si-list:
si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field
or to administer your membership from a web page, go to:
//www.freelists.org/webpage/si-list
For help:
si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field
List forum is accessible at:
http://tech.groups.yahoo.com/group/si-list
List archives are viewable at:
//www.freelists.org/archives/si-list
Old (prior to June 6, 2001) list archives are viewable at:
http://www.qsl.net/wb6tpu