----- Original Message ----- From: "Peter J Nebergall" <iusar4s@xxxxxxxx>
To: <rollei_list@xxxxxxxxxxxxx>
Sent: Sunday, September 30, 2007 8:32 AM
Subject: [rollei_list] shutters
Shutter Question:
I have a number of older pieces, Rollei and Zeiss, with Compur-Rapid
shutters. My Cord 5 has a Synchro-Compur. I've been told the 2 types
are internally different. My question is performance. Does the
Synchro-Compur do a materially better job? How accurate is a
Compur-rapid in good nick?
PeterNebergall
Deckel made a number of shutters under the Compur name. The
earliest ones had a small dial at the top to set the speeds. About
1930 these were replaced with a shutter with the speeds set by a ring
aroung the case. These also have a somewhat different mechanism. The
Compur-Rapid was a rim-set shutter with the addition of a booster
spring for the highest speed. This allowed speeds greater than
1/200th. The first Synchro-Compur shutters were similar to the
Compur-Rapid but had the addition of a delay mechanism for flash
synchronization with flash bulbs.
Compur shutters with the LVS sytem on them are based on the
shutter developed for the Hasselblad camera. These use a clock-motor
type spiral spring instead of the helical springs used in the rim-set,
rapid, and synchro shutters. Curiously enough the old dial set Compur
used a similar drive spring.
Although weak springs get blamed for slow speeds the more usual
cause is dirt.
Note that like nearly all shutters the higher speeds of Compurs of
all types is the _effective_ speed for the full shutter aperture.
Since the shutter blades take a finite time to open and close, and
block some light when partially open, the top speeds are marked as
being faster than they measure when you make the measurement at a
small area at the center of the aperture. For smaller Compurs the
difference in speed is typically about 20%, that is, at small
apertures, or on a simple shutter tester, the top speed of 1/500th
will measure a bit more than 1/400th when the shutter is working
normally. The difference becomes less for longer shutter times because
the opening and closing times are constant for all shutter speeds.
---
Richard Knoppow
Los Angeles, CA, USA
dickburk@xxxxxxxxxxxxx
---
Rollei List
- Post to rollei_list@xxxxxxxxxxxxx
- Subscribe at rollei_list-request@xxxxxxxxxxxxx with 'subscribe' in
the subject field OR by logging into www.freelists.org
- Unsubscribe at rollei_list-request@xxxxxxxxxxxxx with 'unsubscribe'
in the subject field OR by logging into www.freelists.org
- Online, searchable archives are available at
//www.freelists.org/archives/rollei_list
