[rollei_list] What is causing this?
- From: "Peter Schauss" <schauss@xxxxxxxxxxxxxxxx>
- To: <rollei_list@xxxxxxxxxxxxx>
- Date: Sun, 25 Feb 2007 19:55:37 -0500
I have run three rolls of film through my newly acquired Rolleicord Va and
all seem to have a problem as shown in the link below.
http://www.flickr.com/photos/75758245@N00/
When I use Fomapan 200 (developed in Rodinal) I get a whole flock of short
vertical lines on the print. These are especially noticeable when the print
is highly magnified. With Tri-X (developed in HC110) I get black specs
which are you can see in the sky areas of the prints.
I suspect that both of these problems are caused by dust which falls on the
film from someplace inside of the camera since I have had similar problems
with the black specs when using a folder like a Moskva. In this case,
however, I do not see any obvious places inside of the camera which could be
sources for the dust. The interior of the camera looks quite clean.
Any ideas where the dust, if that is what I am seeing, could be coming from?
Thanks,
Peter Schauss
---
Rollei List
- Post to rollei_list@xxxxxxxxxxxxx
- Subscribe at rollei_list-request@xxxxxxxxxxxxx with 'subscribe'
in the subject field OR by logging into www.freelists.org
- Unsubscribe at rollei_list-request@xxxxxxxxxxxxx with
'unsubscribe' in the subject field OR by logging into www.freelists.org
- Online, searchable archives are available at
//www.freelists.org/archives/rollei_list
Other related posts:
