Thanks Jerry, I wish Harry had an outpost in England UK. Anyone have any suggestions for projector repair/ service in the UK? Best to all Claude H Jerry Lehrer wrote: >Claude, > >The best repair service for that high quality projector is Harry Fleenor. He >knows >it intimately. > >BTW, those Gepe mounts are the ones of choice, if you use the anti-Newtons >ring glass on the correct side. > >Jerry > >Claude Hayward wrote: > > > >>Best wishes from England UK, >> >>I bought a PII 6x6 projector a few years ago but must admit to only >>using it infrequently. >>I use Gepe slides - plastic framed, slide sandwiched between glass sheets. >> >>Now Slides tend to stick nearly always if the magazine is forwarded, the >>transport moving out not quite far enough to completely eject the old >>slide, move past and then reverse direction to insert the next slide. >> >>This occurs less often/ works better if I always operate the mag backwards. >>Pulling gently outwards on the slide transport ejects the slide, moves >>on the magazine and inserts the new slide. Projection/ illumination is fine. >> >>Is there any easy adjustment to make or parts to clean up, getting the >>top cover off is easy, the bottom looks more problematic. >> >>Any comments welcome is there a repair guide anywhere or should I look >>for a professional service and tune up? >> >> I was disheartened by reading on an internet trawl that "these >>projectors are always sticky and not to bother with them". >> >>Claude Hayward >> >> > > > > >