I think some film will be wasted advancing to frame 1 on the counter, but
that's all.
On Mon, Nov 14, 2022, 10:10 AM STEPHEN DUNN <bicycle551@xxxxxxxxxxx> wrote:
Hello all,
I made a mistake and pushed the little 120/220 switch. As intended it
immediately set the exposure counter to '0'.
The roll of film is 120 and it had about 4-5 exposures. I understand, if
continuing to use the roll, the gap between them will or might be
affected. Is this so or can I use the roll until it is finished? Is there
a way to know when it is completed?
Or just give up and remove the roll and start with another?
Best Regards,
Steve
