Granted, we have been
-----Original Message-----
From: Bantle, Jack A. <jack.bantle@xxxxxxxxxx>
To: rc3r@xxxxxxxxxxxxx <rc3r@xxxxxxxxxxxxx>
Sent: Sun, Dec 23, 2018 9:37 am
Subject: [rc3r] Re: GBGH Sunday
#yiv9373811500 #yiv9373811500 -- P
{margin-top:0;margin-bottom:0;}#yiv9373811500 Guys:
Club funds should be used to solve large problems like this. After the GBGH
time is over we should have a committee em paneled that looks for a decent
solution to this never ending problem.
Thanks,
JackFrom: rc3r-bounce@xxxxxxxxxxxxx <rc3r-bounce@xxxxxxxxxxxxx> on behalf of
Ken Young <kanawha72@xxxxxxxxxxx>
Sent: Saturday, December 22, 2018 9:58:21 PM
To: rc3r@xxxxxxxxxxxxx
Subject: [rc3r] GBGH Sunday Sat afternoon we had a number of DCS issues.
Variable 2 channel (inside loop) on the TIU started acting strange. Engines
would stutter and stop, would not restart and then suddenly start responding,
even TMCC and conventional engines wouldn't work on the inside loop. The cheap
meter I've left there was showing 58 volts on the track! I don't think it was
actually that high, whatever was going on was "fooling" the meter. Changed the
inside loop over to Variable 1 and everything started working again. Then the
channel shut down altogether. We have voltage going in and nothing coming out.
Right now I have no idea what's wrong. I set up the inside loop for
conventional operation. It appears we are down to one operating channel on this
TIU.
For those working Sunday there will be no DCS on the inside loop. You can run
conventional or TMCC only. DCS should work OK on the outside loop.
Ken