Good call Ken, could that be the same problem with the other tiu and the
bad channel?
Kevin
On Sun, Dec 23, 2018 at 10:40 AM Ken Young <kanawha72@xxxxxxxxxxx> wrote:
I thought about the problem last night and the only thing I could come up
with was Variable 1 somehow got turned off so I went to the GBGH early this
morning. Sure enough I turned Variable 1 on thru the remote and it came
back up. So everything is working again at the moment.
Ken
On 12/23/2018 9:37 AM, Bantle, Jack A. wrote:
Guys:
Club funds should be used to solve large problems like this.� After the
GBGH time is over we should have a committee em paneled that looks for a
decent solution to this never ending problem.
Thanks,
Jack
------------------------------
*From:* rc3r-bounce@xxxxxxxxxxxxx <rc3r-bounce@xxxxxxxxxxxxx>
<rc3r-bounce@xxxxxxxxxxxxx> on behalf of Ken Young <kanawha72@xxxxxxxxxxx>
<kanawha72@xxxxxxxxxxx>
*Sent:* Saturday, December 22, 2018 9:58:21 PM
*To:* rc3r@xxxxxxxxxxxxx
*Subject:* [rc3r] GBGH Sunday
�
Sat afternoon we had a number of DCS issues. Variable 2 channel (inside
loop) on the TIU started acting strange. Engines would stutter and stop,
would not restart and then suddenly start responding, even TMCC and
conventional engines wouldn't work on the inside loop. The cheap meter I've
left there was showing 58 volts on the track! I don't think it was actually
that high, whatever was going on was "fooling" the meter. Changed the
inside loop over to Variable 1 and everything started working again. Then
the channel shut down altogether. We have voltage going in and nothing
coming out. Right now I have no idea what's wrong. I set up the inside loop
for conventional operation. It appears we are down to one operating channel
on this TIU.
*For those working Sunday there will be no DCS on the inside loop. You can
run conventional or TMCC only. DCS should work OK on the outside loop. *
Ken
