Hello again, i found this here: http://www.blids.nl/gallery/Plywood-Recumbent-Building-workshop-2003 ,could be a good solution too. the concept is i think not bad, it should be possible to build a python that way. its not what i plan to do, but it seems to be possible do do this with "normal" (woodworker/homeworker stuff) tools, even at home .. greets jérémy -------- Original-Nachricht -------- > Datum: Thu, 29 May 2008 23:05:27 -0400 > Von: Mike Channon <mchannon@xxxxxxxxxxxxx> > An: python@xxxxxxxxxxxxx > Betreff: [python] no weld python > Hi listees > > I'm thinking of building a no weld python. I think it would be good to > have > one built so that those without welding skills could still build their > own. > Build suggestions before I start are welcome. I'm going to try and > document > the build with photos as I proceed. It may take some time.... > > Mike Channon > London, On, Canada > > ============================================================ > > This is the Python Mailinglist > > //www.freelists.org/list/python > > Listmaster: Jürgen Mages jmages@xxxxxx > > To unsubscribe send an empty mail to > python-request@xxxxxxxxxxxxx > with 'unsubscribe' in the subject field. > > ============================================================ -- Psssst! Schon vom neuen GMX MultiMessenger gehört? Der kann`s mit allen: http://www.gmx.net/de/go/multimessenger ============================================================ This is the Python Mailinglist //www.freelists.org/list/python Listmaster: Jürgen Mages jmages@xxxxxx To unsubscribe send an empty mail to python-request@xxxxxxxxxxxxx with 'unsubscribe' in the subject field. ============================================================